3100 End of Line Conservation Breather Vent
The 3100 end-of-line conservation breather vent is designed for use on atmospheric and low-pressure storage tanks where pressure and vacuum relief is required.
Weight loaded pallets in the vent housing allow the intake of air and the escape of vapours as the tank breathes due to thermal changes and product movement in and out of the tank. The pallets open and close to permit in breathing and out breathing necessary to maintain the tank pressure within permissible limits to avoid damage to the tank.
Maintains Accurate Settings: Minimum setting available is ½ oz/in2 for both pressure and vacuum. Maximum setting upwards to 2.5 psig for pressure and 1 psig for vacuum. If higher settings are required see Valve Concepts Series 4000 Spring Loaded Vents or Valve Concepts Series 5000 Pilot Operated Vents. All vents are tested to high standards for both leakage and set point prior to shipment. A certified test certificate is included with each vent verifying the accuracy of both the pressure and vacuum setting and leakage. A leakage rate of less than 1 SCFH at 90% of set point is verified for both pressure and vacuum.
Condensate Drainage: Self-draining housing body and drip rings keep condensate away from seating surfaces, preventing freezing, binding and clogging. Air-Cushioned Seating. Air-cushion seating provides tight sealing to reduce evaporation losses and the release of toxic vapours. The pallets have outer guiding and centre stabilizing stem to provide self-alignment and tight seating.
- Specifications
- Advantages
- Documents
- Contact
Specifications
Connections:
Available in Sizes 2″ thru 12″. CS and SST vents have Raised Face Flange, Aluminium and FRP vents have Flat Face Flange to mate with standard ASME 150# flange connections. Ref to TABLE 1 on coder for selection of DIN flanges.
Advantages
Modular:
The 3100 end of line conservation breather vent is part of the Valve Concepts, Inc. modular vent product line. The 3100 can easily be field converted to a vacuum only vent, a pressure/vacuum vent with pipe away and can either be direct acting or pilot operated.
Documents
Do you have questions or comments about receiving a quote, our products, solutions and services, and support? Contact us by filling out the form.
- Brendan Merrigan (External) – Mob: 087 2598124
- Conor Foley - Tel: 021 461 7206
- Office Tel: 021 461 7200
-
PumpsNETZSCH
Progressive Cavity Pump
-
PumpsFlowserve
SIHI SuperNova Pump ZDN – Hot Water
-
PumpsNETZSCH
Multi Screw Pump
-
PumpsFlowserve
Mark 3 Recessed Impeller Pump
-
Mixing TechnologyChemineer
Chemineer HS Turbine Agitators
-
Mixing TechnologyGreerco
Greerco Pipeline Mixers
-
PumpsFlowserve
PolyChem S-Series ANSI Overhung, Non-Metallic Pump
-
PumpsFlowserve
Durco Mark 3 Pump – ANSI/ASME standard
Need help with finding the right technical solution?