SIHI SuperNova Pump ZEN – Hot Water

SIHI SuperNova Pump ZEN is a horizontal, single-stage volute casing pumps with dimensions and nominal ratings to EN 22858 in back pull out design, with uncooled balanced mechanical seal.The EN 22858 dimensional standard makes replacement of obsolete or unreliable pumps very easy. The series ZEN has especially been designed for the trouble free handling of hot water up to 230 °C without cooling requirements. The back pull out design permits the removal of the complete bearing unit towards the drive end without removing the pump casing from the pipe work. A spacer type coupling is standard making re-alignment unnecessary.

Pumps of the ZEN  type are part of the family of heat transfer and circulation pumps and are primarily used for circulation of hot water in closed pipe and vessel systems. Therefore their fields of application are energy production, heat transport and industry where hot water as a heat carrier is given preference, despite its high systems pressure, over oil as a heat carrier.

Technical Data:

  • Flow rate: up to 600 m³/h
  • Delivery Head: up to 90 m
  • Speed: max. 3,600 rpm
  • Temperature: Max. 230 °C
  • Casing pressure: up to 40 bar (PN 40)
  • Shaft seal: balanced mechanical seal uncooled
  • Material: nodular iron, cast steel
  • Flange connections: material design 1B DIN EN 1092-2 PN 40 2B DIN EN 1092-1 PN 40
  • Direction of rotation: clockwise, when looking at the pump from the drive end

The SIHI SuperNova Pump ZEN series  has especially been designed for the trouble free handling of hot water up to 230 °C and is distinguished by:

  • A double heat barrier that causes an optimal energy consumption by the pump and reduces the temperature level in the mechanical seal chamber to less than 100 °C without external cooling circuit (see temperature curve on page 3). The service life of the mechanical seal increases considerably.
  • A special design that automatically leads accumulation of gas to exhaust. Consequently, the dry operation of the mechanical seal can be excluded.
  • A programme that comprehends 29 construction sizes and thus guarantees an optimal solution for every operating point.
  • The back pull out design, which permits the removal of the complete bearing unit towards the drive end without removing the pump casing from the pipe work. If a spacer coupling is installed it is also unnecessary to disconnect the motor.

Contact our Pump Specialist Team:

Phil Soltan (External) – Mob: 086 185 3782

Internal Team

Adrian McSweeney – Tel: 021 461 7212

Paul-Fox Morris – Tel: 021 461 7231

Una Long (Pump & Service Support) – Tel: 021 431 7232

Tel: 021 461 7200