ANSI, Overhung, Non-Metallic, Magnetic Drive Pump
The Flowserve PolyChem M-Series ANSI pumps are non-metallic, magnetic drive pumps designed to meet ANSI B73.1M dimensional standards. The M-Series is designed with PFA lined wet ends for superior corrosion resistance and high temperature performance.
- Applications:
Toxic Services,Sea Water,Industrial Water Treatment,Flammable Liquids,Emissions Reduction,Difficult-to-Seal Liquids,Ultrapure Liquids,Chemical Processing,Aquariums,Acid Transfer,Brine,Valuable Liquids,Corrosive Services - Industries:
Electronics,Caustic and Chlor-Alkali,Auxiliary,Acid Transfer,Solvents,Pharmaceuticals,Polymers,Plating, Galvanizing and Other Coatings,Waste Processing,Volatile Organic Compounds.
PFA Lined Wet End is globally preferred for its superior corrosion resistance and temperature allowance.
Rugged Metal Armor meets material specifications of ASTM A395.
Separate Inner Magnet and Impeller Components significantly reduce impeller replacement cost compared with integral inner magnet/impeller designs.
Rotating Shaft Design eliminates need for shaft support obstructions in the casing inlet.
Rugged Silicon Carbide Bearings offer superior wear resistance and chemical inertness.
- Configurations
- Choice of bearing lubrication (long coupled only)
- Operating parameters
- Temperatures from -30°C (-20°F) to 150°C (300°F)
Features:
- Configurations
Close coupled
Long coupled - Close coupled
- Long coupled
- Choice of bearing lubrication (long coupled only)
Oil bath
Grease
Oil mist - Oil bath
- Grease
- Oil mist
- Operating parameters
Pressures to 17 bar (250 psi)
Temperatures from -30°C (-20°F) to 150°C (300°F) - Pressures to 17 bar (250 psi)
- Temperatures from -30°C (-20°F) to 150°C (300°F)
Contact our Pump Specialist Team:
Phil Soltan (External) – Mob: 086 185 3782
Internal Team
Adrian McSweeney – Tel: 021 461 7212
Paul-Fox Morris – Tel: 021 461 7231
Una Long (Pump & Service Support) – Tel: 021 431 7232
Tel: 021 461 7200